Product Reliability
The manufacture of HolyStone ceramic capacitors is carried out in its modern high tech facility in Taiwan. This facility uses modern, state-of the-art equipment, with each process stage and materials carefully controlled. Statistical Process Control (SPC) is used at all process critical stages, to reduce manufacturing and product variations.
Every manufacturing lot is subject to Destructive Physical Analysis (DPA) and Scanning Acoustic Microscopy (SAM). Sample testing (AQL) is also carried out for Solderability, Resistance to Solder Heat, Humidity, Temperature Cycling, Flexture of Substrate and Vibration.
100% electrical testing is carried out for Capacitance, Dissipation Factor, Voltage proof and Insulation Resistance. In addition to this electrical testing HolyStone conducts an ongoing program of Endurance testing to provide customers with reliability data applicable to actual applications.
Samples from a cross section of product types are place onto High Temperature Endurance Test, enabling reliability or F.I.T. (Failures In Time) data to be calculated.
Notes:
- 1 F.I.T. = 1 component failure in 109 component hours
- M.T.B.F. (Hours) = 109/FITS
High Temperature Test Conditions
Test Voltage = 1.7 times rated voltage
Temperature = +125°C
Duration = 1000 hours
The results of this endurance testing are shown below
HolyStone Safety Capacitor Failure Rate
Comments
The failure rate (or F.I.T. rate) of a component, in any specific application, will be largely dependant on the operating temperature and percentage of the maximum working voltage it is subjected to. Designers should take into account their expected ‘system’ failure rate when choosing a suitable component.